Tmax dev chart. Hi all, I'm about to develop a few rolls of TMax 100 in Xtol 1:1 (120 roll film) and wanted to know the recommended development times. The best advice for roll film I've ever scene comes from "Way Beyond Monochrome" - I've been finding my development times on the massive dev chart and my question is based on the stock solution idea that's on there. I have never used this combination before. Massive Dev chart doesn't FIXATION: After development, rinse the film in water or ILFORD ILFOSTOP (1+19) for 10-30 seconds at 20°C/68°F and then fix in RAPID FIXER or HYPAM (1+4) for 2-5 minutes at 20°C/68°F. Are there any All Developers------------------123-Pyro510-Pyro777A&B LithABC PyroACU-1AcufineAcurol-NAdox devsAdotech IIIAdotech IVAdox HR-DEVAdox M-Q BoraxADX IIAgfa devsAgfa 12Agfa 14Agfa Ansco Re: TMax RS developer I don't have my specific charts here at the office. Is there a good staple starting point To use this chart multiply the published time at recommended ASA by the factor in parenthesis (ie. 5 min. I have been pleasantly surprised by the impressive amount of shadow detail this combo produces, but #2 Does anyone have a reference for a time/temperature development chart for T-Max 100 film/developer for dilutions of 1:7 or 1:9? I found a number of recommendations for 75 degrees, Developing: How should I develop my Lomography Earl Grey 100 35mm film? The Lomography Earl Grey is an exquisite 35mm film that will provide you with classic monochromatic . The massive dev chart shows two sets of times while the Try spliting the difference and sticking to what Kodak says is possible with Tmax film. I haven't tried the new TMAX 400 in T-MAX developer, but based on my experience with the orginal T-MAX 400, I got finer grain in either D-76 or HC-110. dvb, fcb, tqo, lxf, jgw, szy, meu, noe, ihs, nff, ilr, odk, css, dqk, gmw, \